Ikelite Carrying Case HG 10 User Manual

IKELITE VIDEO CASE  
P R E P A R A T I O N  
SUPPLEMENTAL INSTRUCTIONS FOR  
PACKAGED WITH HOUSING__________________________________________________  
#6080 Canon HG-10  
• External UR/Pro Color Filter  
• Internal Lens Shade  
• Silicone Lubricant  
COLOR FILTER_____________________________________  
The installation and usage of the external UR/Pro  
color filter is described in the general instruction manual.  
LENS SHADE_______________________________________  
The internal lens shade helps block light reflection/  
refraction caused by the interaction of the external color  
External  
Color Filter  
Internal  
Lens Shade  
filter and the port.  
Carefully thread the lens shade on the front of the  
DO NOT  
camera lens. The lens threads are very fine;  
cross thread. It should screw on  
very easily. If it is difficult to turn, you are cross threading.  
Completely thread the lens shade into the camera to avoid any potential  
clearance or sealing problems when the camera is installed and the housing is sealed.  
SUPER-EYE VIEWFINDER_____________________________________________________  
See exactly what the camera sees underwater using the camera's electronic  
viewfinder in conjunction with the Ikelite Super-Eye, which is permanently mounted  
in the eyeport on the clear back plate. The Super-Eye extends the viewfinder image  
to provide enhanced viewing underwater.  
This supplemental set of instructions describes additional features specific  
to your housing model. Prior to testing the system in the water, please read this  
supplement along with the general instruction manual to become familiar with  
its features and functions.  
Ikelite Video Cases are slightly negative  
Quick Start / Disp.  
in salt water for stability. This housing has  
been water pressure tested at the factory  
and has a working depth of 60m (200').  
Power  
LCD MONITOR / EXTERNAL MIRROR_________________________________________  
The camera's LCD monitor can be viewed from the rear of the housing, using the  
external mirror featured on the side of the housing.  
Open the LCD monitor on the camera, rotate 180°, and then press it back against  
the side of the camera. The external mirror is hinged so that it can be opened to reflect  
the image from the camera's LCD monitor for viewing from the rear of the housing. The  
LCD image will appear opposite, left to right.  
Lid Snap  
Auto / P-Mode  
Port  
HOUSING CONTROLS__________________  
• Power On/Off / Mode  
• Start/Stop  
Eyeport  
Mirror  
Joy Stick #2/  
Function  
• Power Zoom  
• Photo Button  
• Auto / Manual Focus Lock  
• Control Dial  
During transportation, please remember to close the mirror by pressing it against  
the side of the housing.  
Bottom Bar  
Base  
Joy Stick #1  
Control Dial  
BATTERY AND TAPE__________________________________________________________  
Install a fully charged Sony battery on the camera:  
• Type / Card Switch  
• Auto / P-Mode  
Photo  
Button  
Canon NB-2LH, BP-2L13, BP-2L14, BP-2L 24H  
Other brand batteries may not fit inside the housing.  
Make sure you have loaded an appropriate digital cassette tape in the camera.  
• Joy Stick #1  
• Joy Stick #2 / Function  
• Quick Start / Disp.  
Zoom  
Tape/  
Card  
Rec./  
S.S.  
MAIN O-RING #0109________________  
O-rings last several years if properly  
maintained. Control seals should not need  
to be replaced as long as the control shafts  
are kept clean and lightly lubricated.  
 

Graco GPS Receiver 760 User Manual
Grundig CRT Television LXW 68 9740 Dolby User Manual
Halfords Pressure Washer HP 1400 User Manual
Hans Grohe Plumbing Product 06490XX0 User Manual
Harbor Freight Tools Film Camera 90850 User Manual
Honeywell Portable Radio TE821WD User Manual
Honeywell Thermometer TE329ELW User Manual
HP Hewlett Packard Scanner 5370C Series User Manual
HP Hewlett Packard Switch OS 3 User Manual
Impex Home Gym CB 349 User Manual